Smeg SUK61CPX5 Service Manual download pdf (Page 18)

Instructions for the installer

14.INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by competent persons. Corgi gas installers are

approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must

be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990.

This appliance may be installed next to a wall which is higher than the appliance, as shown in the

diagram showing the correct installation conditions. Any wall cupboards or shelves must be at a distance

of at least 750 mm above the work surface.

14.1 Electrical connection

The I.D. plate with techinical data, registration number and brand name is visibily positioned in the

storage compartment.

The plate must not be removed.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out

device on the line, with contact opening distance equal to or greater than 3 mm, located near the

appliance and in an easily reachable position.

Connection to the power supply can be fixed or with a plug and socket. In this case, these must be

suitable for the type of wire used and comply with the norms in force. For each type of connection, it is

vital that the appliance be earthed. Before reconnecting, ensure that the power line is equipped with a

suitable earth. Avoid using adaptors as these may lead to overheating.

The connection terminals are located at the rear of the

appliance. For electrical connections see following diagram.

To access, remove the rear cover.

1 2 ... 13 14 15 16 17 18 19 20

No comments

Smeg SUK61CPX5 Service Manual Page 18