Smeg PV1SR User Manual download pdf (Page 9)

Instructions for the installer

9.3 Overall dimensions

The overall dimensions of the appliance when open and closed are specified below.

9.4 Positioning the hotplate

There are a few things to bear in mind when positioning the

hotplate.

Leave a distance of at least 50 mm between the appliance and the

rear and side walls.

Surfaces close to the appliance must be of non inflammable

material or covered with a non-flammable heat insulating material.

Pay particular attention to fire prevention measures.

If two hotplates are positioned side by side, leave a gap of at least 6-

7 mm between them.

They can also be connected using the special bracket and screws

provided with each product. There are two holes at the front

underneath the hotplate specially for joining the appliances

together, maintaining the minimum safety distance.

9.5 Levelling the hotplate

The hotplate is equipped with height-adjustable feet front and back.

It is advisable to leave the rear section slightly higher so that the product tilts forward, allowing grease

and cooking juices to run to the front of the hotplate and drain through the hole into the drip tray, which

can then be removed and washed separately.

1 2 3 4 5 6 7 8 9

No comments

Smeg PV1SR User Manual Page 9