Smeg CIR34XS Instruction for Use

Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 4 2 POSITIONING OF THE HOB _____________________________________ 6 3 GAS

Instructions for the installer 12 4 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown

Instructions for the installer 13 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appl

Instructions for the installer 14 5.2 Removing the hob (models with built-in control panel) 1. Remove the knobs, the griddles, the burner caps,

Instructions for the installer 15 5.4 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow th

Instructions for the installer 16 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards,

Instructions for the installer 17 6.2 Arrangement of burners on the hob (hobs with separable control panel). 60 cm hobs BURNERS

Instructions for the installer 18 6.3 Arrangement of burners on the hob (hobs with built-in control panel). 60 cm hobs BURNERS 1.

Instructions for the user 19 7 USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted

Instructions for the user 20 7.3 Diameter of containers Burners Ø min. and max. (en cm.) Auxiliary 12-14 Semirapid 16-20

Instructions for the user 21 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a

Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY

Instructions for the user 22 8 CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleanin

Instructions for the user 23 8.2.2 The electric element After use, to make sure that the surfaces are clean and long lasting, the electric elemen

Instructions for the user 24 9 PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should

914771851/ C

Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASIN

Instructions for the installer 6 2 POSITIONING OF THE HOB It is the law that all gas appliances are installed by authorised persons. Clearance

Instructions for the installer 7 Bracket ‘A’ in the 1st slot Bracket ‘A’ in the 2nd slot Bracket ‘B’ Short sides Long sides

Instructions for the installer 8 60 cm 90 cm hob hob A 35 105 B 65 50 C 30 50 D 85 75 2.3 Clear

Instructions for the installer 9 REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust fans shall be installed in acc

Instructions for the installer 10 2.4 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in a

Instructions for the installer 11 3 GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page 12