Smeg SE2951TC2 Service Manual

Contents1. INSTRUCTIONS FOR USE ... 322. SAFETY PRECA

40Instructions for the user5.4 Limiting the cooking durationThe hob has an automatic device which limits the duration of use. If the cooking zone sett

41Instructions for the user6. USING THE HOB6.1 General warnings and adviceOn first connection to the electrical mains, an operating check will be carr

42Instructions for the user6.3 Switching on the hobWhen not in use, the hob will be completely off. Hold down button for two seconds to switch on th

43Instructions for the user6.6 Switching on a triple hot plateTo start heating a triple hot plate, after having set the maximum power level or (on

44Instructions for the user6.8 Control lockControl lock is a device that protects the appliance from accidental or inappropriate use. Useful forpreven

45Instructions for the user6.10 Timer (on some models only)This function is used to set a timer, which will sound a buzzer at the end of the pre-set t

46Instructions for the user6.11 Cooking zone automatic shutdown timer (on some models only)This function is used to program the automatic shutdown of

47Instructions for the user6.12 Secondary menu (Automatic control lock - Showroom - ECO-logic)The hob is equipped with a secondary menu for activating

48Instructions for the user6.13 Cooking guidelinesThe table below shows the power values which can be set, together with the corresponding type of foo

49Instructions for the user7. CLEANING AND MAINTENANCEBefore performing any operations requiring access to powered parts, disconnect the appliance fro

General instructions321. INSTRUCTIONS FOR USETHIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. IT MUST BE KEPT IN ITS ENTIRETYAND IN AN ACCESSIBLE PLA

50Instructions for the user8. TROUBLESHOOTINGPROBLEM POSSIBLE CAUSES SOLUTIONThe hob does not work.- The hob is not wired in or the mainswitch is no

51Instructions for the installer9. INSTALLATION9.1 Safety instructions for installing in kitchen unitsUSE PERSONAL PROTECTIVEEQUIPMENT WHENINSTALLING

52Instructions for the installer9.2.2 Hobs with a frameL (mm) X (mm) Y (mm) A (mm) B (mm) C (mm)570 560 500 50 min. 50 min. 750 min.760 750 500 50 min

53Instructions for the installer9.3.2 Over built-in ovenIf installed on top of an oven, the latter must be equipped with a cooling fan.The distance be

54Instructions for the installer9.5 Cutting out the counter top (only on models without frame with straightedge)The illustrations indicate the additio

55Instructions for the installer9.6 Positioning the fastening clipsTo ensure the hob is fixed and centred as accurately as possible, the clips provide

56Instructions for the installer9.8 Electrical connectionMake sure that the voltage and capacity of the power line conform to the data shown on the pl

57Instructions for the installerHOB TYPE(CM)POSSIBLE CONNECTION TYPESCABLE TYPE(if not present)60 - 70 -90380 - 415 V 3N~ 5-pole 5 x 1.5 mm² H05V2V2-F

58Instructions for the installer9.8.1 Terminal diagramThe adjacent diagram illustrates the power supply terminalfrom below, with no cables connected.

General instructions33DO NOT PUT EMPTY SAUCEPANS AND FRYING PANS ON COOKING ZONES WHICH HAVE BEENSWITCHED ON.DO NOT USE THE HOB IF PYROLYSIS IS TAKING

General instructions342. SAFETY PRECAUTIONSCONSULT THE INSTALLATION INSTRUCTIONS FOR THE SAFETY STANDARDS APPLICABLE TOELECTRICAL APPLIANCES AND FOR T

General instructions35NEVER LEAVE THE SWITCHED ON HOB UNATTENDED.BE AWARE OF HOW RAPIDLY THE COOKING ZONES HEAT UP. DO NOT PLACE EMPTYSAUCEPANS ON THE

Instructions for disposal363. ENVIRONMENTAL CARE3.1 Our environmental carePursuant to Directives 2002/95/EC, 2002/96/EC, 2003/108/EC, relating to the

37Instructions for the user4. BEFORE FIRST USEBefore cooking for the first time, all labels and protective films applied to the inside or outside of t

38Instructions for the user5. GET TO KNOW YOUR APPLIANCEThe appliance has cooking zones with various diameters and power levels depending on the model

39Instructions for the userZoneOutside diameter (mm)Max power absorbed (W) *Inside diameter (mm)Max power absorbed (W) *Middle diameter (mm)Max power