Smeg SC336WH Service Manual download pdf (Page 25)

Instructions for the Installer

12. INSTALLING THE APPLIANCE

12.1 Electrical connection

The nameplate with the technical data, serial number and mark is in a

visible position on the oven door frame.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical

system safety regulations.

If a permanent connection is used, the appliance's power supply line must

be fitted with an omnipolar breaking device with contact gap of at least

3mm, located in an easily accessible position close to the appliance itself.

If a socket and plug connection is used, check that they are of the same

type. Do not use reducers, adapters or junctions since they may cause

overheating or burns.

Operation at 220-240 V~: use a

H05RR-F three-wire cable (cable

of 3 x 1.5 mm

The earth wire (yellow-green)

must be at least 20 mm longer

than the other wires at the end

for connection to the appliance.

1 2 ... 20 21 22 23 24 25 26 27

No comments

Smeg SC336WH Service Manual Page 25