Smeg BQ6030 User Manual download pdf (Page 6)

Instructions for the Installer

ADJUSTING THE BURNER MINIMUM SETTING

CONVERTING FROM LPG TO NATURAL GAS

Perform the operations described below on all the gas

taps.

1 Pull off the knob.

2 Make sure that the by-pass inside is screwed fully

down. Use a screwdriver inside or on the side of

the rod (see right).

3 Turn the bypass as stated in the BURNER

CHARACTERISTICS, NOZZLES AND GAS

CONSUMPTION table (see page 10).

4 When adjustments are complete, fit the knob, light

the relative burner and turn it to the minimum

setting . The flame should be even at the

minimum setting.

5 Check that the flame remains stable when the

knob is turned quickly from the maximum to the

minimum setting. The flame must not go out.

6 If the minimum flame is not even, remove the knob

and make small clockwise or anti-clockwise

adjustments to the bypass then check stability

again. Otherwise the minimum flame has been

adjusted successfully.

CONVERTING FROM NATURAL GAS TO LPG.

Perform the operations described below on all the gas

taps.

1 Pull off the knob.

2 Turn the by-pass inside, screwing it fully down.

Use a screwdriver inside or on the side of the rod

(see right).

3 For the grill tap, after screwing the bypass fully

down back it off by 1+1/4 turn.

1 2 3 4 5 6

No comments

Smeg BQ6030 User Manual Page 6