Smeg Electrical Built-in Hot Plates SBC30 User Manual download pdf (Page 10)

TRANSFORMATIONS

Before any kind of transformation is necessary

to cut off the electricity.

6) TRANSFORMATION OF THE INPUT

TYPE

The standard equipment of the appliances is for

single phase connection. In any case, under proper

changes, they can be fed with a three phase

system.

To obtain these changes, please, follow the

instructions:

a) Take off the panel stuck by screws "V" (see

fig. 14).

b) Remove the connection jumpers on the clamp

following the scheme of fig.15 of page (attached on

the body).

c) Insert the input cable with adequate section (see

scheme paragraph 5) into the chock.

d) Connect the phase cable into the clamp and the

"earth" cable in the relative clamp.

e) Hold up the input cable with the pertinent

stopcable.

f) Replace the panel in its seat and hold up with the

pertinent screws "V" (see fig. 14).

FIG. 14

FIG. 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

No comments

Smeg Electrical Built-in Hot Plates SBC30 User Manual Page 10