Smeg P106 Instruction Manual download pdf (Page 7)

Instructions for the installer

4.1 Connection to LPG

Use a pressure regulator and make the connection to the tank according to the

provisions of standards regulations in force. Make sure that feed pressure conforms to

the levels shown in the table in Section “5.2 Regulation for LPG ”.

4.2 Ventilation of rooms

The hob may be installed only in rooms with permanent ventilation, as required by

standards regulations in force. The room in which the hob is installed must have

sufficient air flow to satisfy the requirements of normal gas combustion and of

necessary air exchange in the room. The air intakes, protected by screens, must be

appropriately sized (regulations in force) and placed so as not to be blocked in any

way.

The room where the oven is installed should be suitably ventilated to avoid

overheating or excess humidity produced by cooking, and in the case of lengthy use a

window should be opened or the speed of any ventilators should be increased.

4.3 Discharge of combustion products

Discharge of combustion products must be guaranteed by means of hoods connected

to a natural draught flue with certain efficiency, or by means of forced aspiration.

An efficient aspiration system requires careful planning by a specialist capable of

installing it, respecting the positions and distances prescribed by standards. After

installation, the installer must issue a certificate of conformity.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Models	Document Type
TZ-50	User Manual Genie TZ-50 User Manual, 39 pages
TZ-50	User Manual Genie TZ-50 User Manual, 41 pages
SUPERLIFT 33547	User Manual Genie SUPERLIFT 33547 User Manual, 26 pages

Smeg P106 Instruction Manual Page 7