Smeg SE995XT-7 Instruction Manual download pdf (Page 30)

Instructions for the Installer

15.2 Positioning the oven

The appliance is designed for building-in to cabinets made from any heat-

resistant material. Comply with the dimensions shown in figures 1, 2, and

3. When installing under worktops, comply with the dimensions shown in

figure 1-3. When installing under worktops incorporating combined hobs,

a gap of at least 110 mm must be left from any side wall, as shown in

figure 1.

When installing in tall units, comply with the dimensions shown in figure

bearing in mind that the top/rear of the unit must have an opening 80-90 mm

deep. Screw the 2 screws

into the inside of the frame (fig.

). For

installation under counter-top hobs, make sure that the rear/bottom of the

unit has an opening similar to that shown in figure

(ref.

). See the

instructions supplied with the hob for the relative positioning and fixing

procedures.

Never use the door for leverage when inserting

the oven in the cabinet. Never apply excessive

pressure to the open door.

1 2 ... 25 26 27 28 29 30

No comments

Smeg SE995XT-7 Instruction Manual Page 30