Smeg CO100 Troubleshooting Guide download pdf (Page 5)

INSTRUCTIONS FOR USE

3. The green LED (if provided) is off and the appliance is

not working.

•

Is there a power failure?

•

Is the plug properly inserted in the socket?

•

Is the electric cable intact?

4. The green LED (if provided) is off and the appliance is

working.

•

The green LED is not working. Contact the After Sales

Service for a replacement.

5. The compressor runs continuously.

•

Have hot foods been put in the appliance?

•

Has the appliance lid been left open for a long time?

•

Is the appliance placed in a very warm room or near heat

sources?

•

Is the thermostat setting correct?

•

Has the fast freeze function (depending on model) been

pressed by mistake?

6. Too much ice on the upper edge.

•

Are the defrost water drainage plugs correctly positioned?

•

Is the appliance lid properly closed?

•

Is the appliance lid seal damaged or deformed? (See chapter

“Installation”)

•

Have the 4 protection pieces been removed? (See chapter

“Installation”)

7. Formation of condensate on the external walls of the

appliance.

•

It is normal for condensation to form under certain

atmospheric conditions (humidity above 85%) or if the

appliance is located in a damp or poorly ventilated room.

The performance of the appliance is in no way affected.

8. The layer of ice on the internal walls of the appliance

is not uniform.

•

This phenomenon is quite normal.

SAFEGUARDING THE ENVIRONMENT

1. Packing

The packaging material is entirely recyclable, and marked with

the recycling symbol. Follow local regulations for scrapping.

Keep the packaging materials (plastic bags, polystyrene parts,

etc.) out of reach of children, as they are potentially dangerous.

2. Scrapping

The appliance is manufactured using recyclable material .

This appliance is marked according to the European directive

2002/96/EC on Waste Electrical and Electronic Equipment

(WEEE).

By ensuring this product is disposed of correctly, you will help

prevent potential negative consequences for the

environment and human health, which could otherwise be

caused by inappropriate waste handling of this product.

The symbol on the product, or on the documents

accompanying the product, indicates that this appliance may

not be treated as household waste. Instead it shall be handed

over to the applicable collection point for the recycling of

electrical and electronic equipment.

Before scrapping, make the appliance unusable by cutting off

the power cable and removing the doors and shelves so that

children cannot easily climb inside the appliance.

Disposal must be carried out in accordance with local

environmental regulations for waste disposal. Deliver the

appliance immediately to an authorized dump; do not leave it

unattended even for a few days, since it is potentiallydangerous

for children. For more detailed information about treatment,

recovery and recycling of this product, please contact your

local city office, your household waste disposal service or the

shop where you purchased the product.

Information:

This appliance does not contain CFCs. The refrigerant circuit

contains R134a (HFCs) or R600a (HCs), see the rating plate

inside the appliance.

Appliances with Isobutane (R600a):

Isobutane is a natural gas with low environmental impact.

Caution is required, however, since isobutane is flammable.

Therefore, it is essential to ensure that refrigerant pipelines

are not damaged.

This product contains Fluorinated Greenhouse Gases

covered by the Kyoto Protocol, the refrigerant gas being in a

hermetically sealed system. Refrigerant gas: R134a has a

Global Warming Potential (GWP) 1300.

Declaration of conformity

•

This appliance is designed to store food and is manufactured in

conformity with European Directive 90/128/EEC, 02/72/EEC

and Regulation (EC) No. 1935/2004

•

Thisappliance is designed, manufactured, and retailed in

compliance with:

- the safety objectives prescribed in the Low Voltage

Directive 2006/95/CE (which replaced Directive

73/23/CEE as amended);

- the protection requirements of the "EMC" Directive

89/336/EEC amended by Directive 93/68/EEC.

•

The electrical safety of the appliance can only be guaranteed if

the product is connected to an approved earth connection.

AFTER-SALES SERVICE

Before calling out an After-sales Service technician,

make sure that:

the plug is properly inserted in the socket;

the mains electrical supply is present;

the meter box safety switch has not tripped;

the power supply voltage corresponds to that indicated

on the appliance;

if the problem persists, contact the After-sales Service,

tel. 199.135.135 * (in contact with your local area

Technician).

Before calling the After-sales Service, be sure to have

the following information ready:

•

your full address and telephone number;

•

the appliance model;

•

the serial number (“S/N”) of the appliance, indicated on

the accompanying documentation and on the data plate on

the rear of the unit;

•

the nature of the fault.

* Maximum cost 14 cents/min (VAT included) without connection charge

from landlines. Average cost 39 cents/min (VAT included) and maximum

connection charge of 15 cents (VAT included) from mobile networks.

For further details on mobile charges, contact your network operator.

1 2 3 4 5 6

INSTRUCTIONS FOR USE 2
5019 613 01065 6

Comments to this Manuals

No comments

Smeg CO100 Troubleshooting Guide Page 5

Comments to this Manuals

Related products and manuals for Unknown Smeg CO100