Smeg WDI147 Instruction Manual

WASHER-DRYER INSTRUCTION MANUAL EN

EN 9 4. USING THE APPLIANCE FOR WASHING 4.1 PREPARING THE ITEMS FOR WASHING 1. Subdivide the items for washing

EN 10 4.4 LOADING THE ITEMS FOR WASHING 1. Open the door and load the laundry, distributing it evenly over the dru

EN 11 4.6 POWDER DETERGENT DOSES Laundry with normal dirt 1. Choose a programme without prewash. 2. Pour

EN 12 4.10 SWITCHING ON THE APPLIANCE AND SELECTING THE WASHING PROGRAMME To switch on the appliance and select the

EN 13 4.11 SELECTING AND CONFIRMING OPTIONS 1. The Option Selection button can be used to select the foll

EN 14 4.12 TIME TO END 1. The Time to End key can be pressed repeatedly to select the time after which the wash

EN 15 4.14 INTERRUPTING OR CHANGING THE WASHING PROGRAMME The washing programme in progress can be interrupted at a

EN 16 4.17 OPENING THE APPLIANCE IN AN EMERGENCY In the event of a power failure, the door is opened using the mech

EN 17 5. USING THE APPLIANCE FOR DRYING 5.1 GENERAL During drying cycles, the water tap must be turned on and the

EN 18 5.2 WASH-AND-DRY PROGRAMME Automatic washing and drying can be carried out in the tough fabrics (cotton and c

1 EN Contents 1. Precautions for safety and use 2 2. Installation instructions 5 3. Description of controls 8 4. Using the appliance fo

EN 19 5.5 CLEAN PROGRAMME To keep the appliance operating at peak efficiency over time, it has a CLEAN programme fo

EN 20 6. CLEANING AND MAINTENANCE Important – Before carrying out any cleaning or maintenance procedure, the plug m

EN 21 3. Extract the drain hose ”A”. Warning: if the hose is hot, the water is hot or boiling hot. Place a shal

EN 22 7. TROUBLESHOOTING This produce complies with the relevant regulations governing the safety of electrical equ

EN 23 11 Appliance does not spin Anti-imbalance safety device tripped because laundry not evenly distrib-uted in dr

PROGRAM GUIDEProgramsTemp. (°C)Max. Spin (rpm)Max. washing load (kg)Max. drying load (kg)Prewash Wash Softner Prewash Intensi

ISTRUZIONI DI MONTAGGIO DELLE LAVATRICI INTEGRABILI IT ASSEMBLY INSTRUCTIONS FOR BUILT-IN WASHING MACHINES EN MONTAGEANLEITUNG FÜR EINBAUBARE

4 ASSEMBLY INSTRUCTIONS FOR BUILT-IN WASHING MA-CHINES IMPORTANT - This machine complies with current safety regulations govern-ing electrical

5 Place the template of the inner side of the panel and match the height of the baseboard with the lower edge of the panel (fig. 4) using the gra

6 impossible to touch live components and a tool must be required to remove it. Our company declines all liability for failure to observe t

EN 2 READ THE INSTRUCTIONS Attention! You are advised to read all the instructions in this manual carefully; it will

ca. 82kg820mm16mm560mm596mm150mm58mm820mm!!!!19A B2

2233121211117710108899221133446655454112323CC66557788CA B-A B-C9DD22113344AB3- A3-B3

Ø2mmØ2mm13mm13mm16...21mmØ 35mmØ35mm13mm13mm592...595mm16...21mm592...595mmeeeeeeeeUnterkanteLower edgeCôté inférieurLato inferioreLado inferiorOnd

11223311223311?7892124356

91011

EN 3  The appliance is only disconnected from the electricity supply if the plug has been removed from the socket o

EN 4  Fabric softeners, or similar products, should be used as specified by the fabric softener instruc-tions. 

EN 5 2. INSTALLATION INSTRUCTIONS Important! The appliance must be installed by a qualified engineer in complianc

EN 6 2.2 POSITIONING AND LEVELLING 1. Place the appliance in the chosen position. 2. Level the applia

EN 7 2.3 CONNECTING TO THE WATER SUPPLY 1. Check that the water supply pressure is in the following r

EN 8 3. DESCRIPTION OF CONTROLS 3.1 CONTROL PANEL All the appliance's control and monitoring devices are pla