Smeg PGA64 User Manual download pdf (Page 11)

Instructions for the installer

6. POSITION NEAR THE COUNTER TOP

The following operation requires building and/or carpentry work so must be carried out by

a competent tradesman.

Installation can be carried out on various materials such as masonry, metal, solid wood or

plastic laminated wood as long as they are heat resistant (T 90°C).

6.1 Fixing to a support structure model with traditional casing

(fig. 1)

Create an opening with the dimensions

shown in the figure in the top surface of the

counter, keeping a minimum distance of 50

mm from the rear edge. This appliance can

be mounted against walls higher than the

work surface on condition that a distance of

"X" be kept between the appliance and the

wall as shown in the figure so as to avoid

damage from overheating. Make sure that

there is a minimum of 750 mm between the

hob and any shelf that may be installed

directly above it.

Carefully position the supplied insulating

seal on the outer edge of the hole on the

top hob, as indicated in figure 2. Try and

make it stick to the whole surface by

applying light hand pressure. The front and

back sides of the seal must be touching the

hole.

Carry out this operation by supporting the

hob on the isolating seal and using screws

and clamping brackets (Fig. 3) to fix the

hob to the support structure, in order to

obtain the complete flatness.

Trim any excess trimming from border A

with care (Fig.4). The quotes in figure 2 are

references for the hole on the inside of the

trimming. The small brackets in figure 3 are

only positioned after having mounted the

hob.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Smeg PGA64 User Manual Page 11