Smeg PGA64 User Manual download pdf (Page 16)

Instructions for the installer

6.6 Gas connection

Connection to the gas supply network can be made using a rigid copper hose or

a flexible steel hose with a continuous wall and in compliance with the guidelines

established by the applicable standard.

Once the operation is complete, check the hose fittings for leaks using a soapy

solution; never use a flame.

The hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. To set it up

for supply using other types of gas, see “3. ADAPTATION TO DIFFERENT

TYPES OF GAS”. The gas inlet connection is threaded ½” external gas (ISO

228-1).

Connection with a rigid copper

hose:The connection to the gas supply

network must be made in such a way that it

does not cause stresses of any type on the

appliance.

The connection can be made using the

adapter unit D with double cone, always

inserting gasket C (provided) in between.

Connection with a flexible steel

hose:Use only continuous wall stainless

steel hoses that comply with current

legislation, making sure to always insert

the supplied gasket C between the

connection A and the flexible hose B.

Installation with the flexible hose must be carried out so that the length of the

piping does not exceed 2 metres when fully extended; make sure that the hoses

do not come into contact with moving parts and that they are not crushed in any

way.

6.7 Connection to liquid gas

Use a pressure regulator and make the connection on the gas cylinder following

the guidelines set out in the regulations in force.

Make sure that the supply pressure complies with the values indicated in the

table shown in the paragraph "7.2 Burner and nozzle characteristics table”.

1 2 ... 11 12 13 14 15 16 17 18 19

No comments

Smeg PGA64 User Manual Page 16