Contents 21 1. Precautions for safety and use________________________ 22 2. Fitting the appliance in the top ________________________ 23 2.1 Fixin
Instructions for the Installer 30 5.4 Adjusting the primary air flow Refers to the gap “X” in mm. BURNER G20 20 mbar G30/G31 30/37 mbar 0.5 9.
Instructions for the Installer 31 5.5 Reassembling the hob skin Reverse the procedure described in point “5.1 Removing the hob skin”. When repl
Instructions for the User 32 6. Description of controls 6.1 The front panel All the hob's control and monitoring devices are placed togeth
Instructions for the User 33 7. Using the hob Check that the fixing cover plates E, the burners, the flame diffuser rings and the pan stands a
Instructions for the User 34 To fit the pan stand, first align it with the fixing pin (1) and then lower it into place on the hob, taking care
Instructions for the User 35 After performing the operations described above (for each pan stand), the hob will beas shown below, with the feet of
Instructions for the User 36 7.2 Lighting burners with safety device The burner it controls is shown next to each knob (the example her
Instructions for the User 37 7.4 Pan diameters BURNERS min. and max. Ø (in cm) 1 Auxiliary 7-18 2 Semi rapid 3 Rapid 4 Ultra Rapid 10-24 18-
Instructions for the User 38 8. Cleaning and maintenance Before carrying out any operations, disconnect the appliance from the electricity supp
Precautions for Safety and Use 22 1. Precautions for safety and use THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND
Instructions for the Installer 23 2. Fitting the appliance in the top If the hob has to be adapted for a type of gas different from the one f
Instructions for the Installer 24 2.2 Fitting the adhesive foam rubber strip Fit the adhesive foam rubber strip (supplied with the hob) around
Instructions for the Installer 25 2.4 Fitting the hob into the hole in the work-top Take special care when fitting the hob into the work-top. If
Instructions for the Installer 26 3. Electrical connection Check that the power supply line voltage and size are as specified on the nameplate
Instructions for the Installer 27 4. Gas connection If the appliance is installed above an oven, the gas hose must be passed around the back of t
Instructions for the Installer 28 5. Adapting to different types of gas The operations described below must be carried out with the appliance n
Instructions for the Installer 29 5.2 Adjusting for bottled gas Undo the screw C and push the air regulator D fully down. Remove the nozzle E with
Comments to this Manuals