Smeg SF109 User Manual download pdf (Page 27)

Cleaning and maintenance

59

EN

Removing the door seal (not on pyrolytic

models)

To permit thorough cleaning of the oven, the

door seal may be removed. There are

fasteners on all four sides to attach it to the

edge of the oven. Pull the 4 edges of the

seal outwards to detach the fasteners.

What to do if...

The display is completely off:

• Check the mains power supply.

• Check whether an omnipolar switch

upstream of the appliance supply line is

in the “ON” position.

The appliance does not heat up:

• Check whether it has been set in

“showroom” mode (for further details see

“Secondary menu”).

The controls do not respond:

• Check whether it has been set in “child

lock” mode (for further details see

“Secondary menu”).

The cooking times are longer than those

indicated in the table:

• Check whether it has been set in “low

power” mode (for further details see

“Secondary menu”).

After the automatic cleaning cycle

(pyrolysis) it is not possible to select a

function:

• Verify whether the door locking device

has deactivated. If it has not, the oven

has a safety device that does not allow

functions to be selected while the door

locking device is active. This is because

the temperature inside the oven is still too

high to permit any type of cooking.

The display shows “ERR4”:

• The door lock has not properly attached

to the door. This might be because the

door was accidentally opened during

the door lock activation. Switch the oven

off and on again, waiting a few minutes

before selecting a new cleaning cycle.

If the door is opened during a fan-assisted

function, the fan stops:

• This is not a fault. It is a normal operation

of the appliance, useful when cooking

foods in order to avoid excessive heat

escaping. When the door is closed, the

oven will return to normal operation.

If the problem has not been

resolved or in the case of other

types of fault, contact your local

technical support centre.

1 2 ... 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments