Smeg CS19ID-6 Service Manual download pdf (Page 4)

Instructions for the Installer

2. INSTALLING THE APPLIANCE

This appliance has fire protection (type Y) and can be installed against

walls higher than the work surface.

In compliance with Electromagnetic Compatibility regulations, the

electromagnetic induction hob is classified in Group 2 and Class B (EN

55011)

2.1 Electrical connection

Check that the voltage and size of the power supply line are as specified

on the nameplate inside the storage compartment. This nameplate

must never be removed.

The appliance's power supply line must be fitted with an omnipolar

breaking device with contact gap of at least 3 mm, located in an easily

accessible position close to the appliance itself.

The appliance has a terminal board on its rear for the electrical

connection (see diagram below). To access it, remove the back cover.

1 2 3 4 5 6 7 8 9 ... 31 32

No comments

Smeg CS19ID-6 Service Manual Page 4