Smeg SA9058X Instruction Manual download pdf (Page 6)

Instructions for the installer

3.2 Gas connection

This appliance is suitable for installation with Natural Gas or ULPG (propane).

Refer to page 13 for the relevant burner pressure and appropriate injector sizes.

When the appliance is to be connected to Natural Gas then the pressure

regulator supplied must be fitted to the gas inlet. A test point (for checking the gas

pressure) is supplied either with the regulator or as a separate fitting in the case

of LPG (propane) appliances.

Connection of the appliance to the gas supply must be in accordance with the

requirements of AS5601. A ½” BSP connector at the inlet is recommended and

the gas supply line to the appliance must be of adequate length to allow sufficient

withdrawal of appliance for service or disconnection and be:

1. annealed copper pipe or;

2. Flexible hose according to AS/NZ1869 & be at least Class “B”, 10 mm

diameter, max length 100 mm.

The cooker must be installed with provision to allow the gas to be turned off and

disconnected for servicing and removal of the appliance as required from the gas

supply.

Before the cooker is operated make certain all relevant parts are placed in the

correct position.

When the installation is completed the installation connections of cooker will

require to be leak tested, the burner operating pressure and flame checked and

adjusted.

Warranty service calls do not cover these adjustments!

To check the operating pressure of the appliance it is recommended at least 2

large size burners are used. Ensure appliance is secured to wall when installation

is completed.

N.G. The regulator supplied must be fitted to the ½ BSP thread at the rear of the

appliance. An approved manual shut-off valve must be installed. The N.G.

regulator must be checked and adjusted to 1.0kPa after installation.

U.L.P.G. Can be connected to the inlet fitting directly. The pressure must be

checked to ensure it is operating at 2.75kPa. A separate test point fitting must

be installed between the piping & the appliance for the pressure to be checked

to ensure it is operating at 2.75kPa.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Smeg SA9058X Instruction Manual Page 6