Smeg XXPTS725 User Manual download pdf (Page 3)

Instructions for the Installer

2. Fitting the appliance in the top

The procedures required below must be carried out by a skilled builder and/or joiner.

The hob can be installed on various materials, including masonry, metal, solid wood

and wood finished with plastic laminates, provided the material is heat-resistant

(T 90° C).

2.1 Fixing to the supporting structure

Make a hole in the cabinet top with the dimensions shown here, maintaining a

distance of at least 50 mm from the rear edge. This appliance may be installed

against walls higher than the worktop surface, provided the distance "X" shown here is

maintained, in order to prevent damage due to overheating. Make sure that there is at

least 750 mm between the hob burners and a shelf or hood (if any) placed vertically

above them.

(*:6 Burner Hob, UR2 at Side)

If the hob is installed above a cupboard with doors, a separator panel must be

installed underneath it. Leave a gap of at least 10 mm between the bottom of the hob

and the surface of the panel, which must be easily removable to allow sufficient

access for any servicing procedures.

Installation of an oven without cooling fan underneath the hob is forbidden.

In case of installation on a hollow compartment with doors, a separating panel has to

be placed under the hob. Keep a minimum distance of 10 mm between the bottom of

the unit and the panel surface. The panel has to be easily removable to allow access

in the event of technical service.

1 2 3 4 5 6 7 8 ... 14 15

No comments

Smeg XXPTS725 User Manual Page 3