Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE ______________________ 4 2 POSITIONING OF THE HOB ______________________________________ 6 3 EL
Instructions for the installer 12Burner Rated heating capacity Natural gas – G20 2.0 kPa Nozzle diameter 1/100 mm Reduced flowrate (W) Auxilia
Instructions for the installer 13 Burner Rated heating capacity Town gas G110 – 0.8 kPa Nozzle diameter 1/100 mm Reduced flowrate (W) Auxilia
Instructions for the installer 14 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, th
Instructions for the installer 15 6.3 Arrangement of the burners on the hob Burners 1. Auxiliary 2. Semi rapid 3. Rapid 4. Rapid lar
Instructions for the user 16 7USINGTHEHOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctl
Instructions for the user 17 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed
Instructions for the user 18 8 CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the appliance. 8.1 Cleaning
Instructions for the user 19 8.2.2 The cover Clean the glass or steel cover, where mounted, with warm water. Never use abrasive sponges or deterge
Cod. 914772070/B
Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRET
Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING
Instructions for the installer 6 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out
Instructions for the installer 7 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on
Instructions for the installer 8 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and co
Instructions for the installer 94.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions of
Instructions for the installer 105 ADJUSTMENT FOR DIFFERENT TYPES OFGAS Before performing any cleaning or maintenance work, disconnect the appli
Instructions for the installer 115.2 Nozzle replacement and primary air adjustment Loosen screw A and push support B all the way. Use a double
Comments to this Manuals