Table of contents 3 1. Precautions for safety and use_________________________ 4 2. Fitting the appliance in the top _________________________ 5 2.
Instructions for the Installer 12 5.2 Adjusting for bottled gas Undo the screw A and push the support B fully down. Remove the nozzle C with asp
Instructions for the Installer 13 5.4 Adjusting the primary air flow Refers to the gap “X” in mm. BURNER NG – 1.0 kPa ULPG – 2.75kPa Auxiliary
Instructions for the Installer 14 5.8 Hob burner layout Burner type 1 Auxiliary 2 Semi rapid 3 Rapid 4 WOK Double flame 5 WOK 6 Rapid 7 Rapid
Instructions for the User 15 6. Description of controls 6.1 The front panel All the hob's control and monitoring devices are placed together
Instructions for the User 16 7. Using the hob Check that the fixing rings, burners, flame diffuser rings and pan stands are fitted correctl
Instructions for the User 17 7.4 Pan diameters BURNERS 1. Auxiliary 2. Semi rapid 3. Rapid 4. WOK double flame 5. WOK 6. Rapid 7. Rapid
Instructions for the User 18 8. Cleaning and maintenance Before carrying out any operations, disconnect the appliance from the electricity sup
Precautions for Safety and Use 4 1. Precautions for safety and use THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND K
Instructions for the Installer 5 2. Fitting the appliance in the top The procedures required below must be carried out by a skilled builder an
Instructions for the Installer 6 edge of the gasket B. The dimensions in the drawing below refer to the hole on the inside edge of the gasket.
Instructions for the Installer 7 3. Electrical connection Check that the power supply line voltage and size are as specified on the nameplate und
Instructions for the Installer 8 3.1 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances
Instructions for the Installer 9 2 Side clearances – (Measurements B & C) Where B, measured from the periphery of the nearest burner to any ver
Instructions for the Installer 10 4. GAS CONNECTION This appliance is suitable for installation with Natural Gas or LPG (propane). Refer to pa
Instructions for the Installer 11 5. Adapting to different types of gas Before carrying out the operations described below, disconnect the appli
Comments to this Manuals