Smeg SE2644ID1 Datasheet download pdf (Page 11)

Instructions for the installer

8. INSTALLATION

8.1 Technical information

Hob type See rating plate

Electrical connections

220-240V~ 50/60Hz / 380-415V 2N∼ 50/60Hz / 380-415V 3N∼ 50/60Hz

HOB RATING

Maximum electrical power See rating plate

8.2 The rating plate

Make sure that the voltage and capacity of the power

line conform to the data shown on the plate located

under the casing. Do not remove this plate for any

reason.

Serial N°

Model

8.3 Electrical connection

THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL

SYSTEM SAFETY REGULATIONS.

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE

COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE

REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE IS BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB,

FOLLOWING THE INSTRUCTIONS. IF THE HOB FAILS TO OPERATE, AFTER CHECKING THAT

YOU HAVE CARRIED OUT THE INSTRUCTIONS CORRECTLY, DISCONNECT THE APPLIANCE

FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE.

N VER ATTEMPT TO REPAIR THE APPLIANCE.

PASS THE POWER SUPPLY CABLE THROUGH THE BACK OF THE UNIT, TAKING CARE THAT IT

DOES NOT TOUCH THE BOTTOM CASING OF THE HOB OR THE OVEN (IF ANY) INSTALLED

UNDERNEATH IT.

IF A PLUG AND SOCKET CONNECTION IS BEING USED MAKE SURE THAT THE PLUG AND

SOCKET ARE COMPATIBLE. AVOID USE OF ADAPTERS AND SHUNTS AS THESE COULD

CAUSE OVERHEATING AND RISK OF BURNS.

IF A FIXED CONNECTION IS BEING USED FIT POWER LINE WITH AN OMNIPOLAR CIRCUIT

BREAKER WITH A CONTACT OPENING GAP EQUAL TO OR GREATER THAN 3 MM, IN AN

EASILY ACCESSIBLE POSITION IN PROXIMITY TO THE OVEN.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Smeg SE2644ID1 Datasheet Page 11