Smeg SE2644ID1 Datasheet download pdf (Page 13)

Instructions for the installer

8.4 Positioning of the hob

The following operation requires building and/or carpentry work so must be carried out by a

competent tradesman.

Installation can be carried out on various materials such as masonry, metal, solid wood or

plastic laminated wood as long as they are heat resistant (T 90°C).

Create an opening with the dimensions shown in the figure in the top surface of the counter,

keeping a minimum distance of 50 mm from the rear edge.

This appliance can be mounted against walls higher than the work surface on condition that a

distance of 110 mm be kept between the appliance and the wall as shown in the figure so as to

avoid damage from overheating.

Make sure there is a minimum of 750 mm between the hob and any shelf that may be installed

directly above it.

The dimensions indicated in the figure are the

same for all models without a frame.

The dimensions indicated in the figure are the

same for all models with a frame.

Below is supplied the table of comparison between

the dimension Y to be created in the worktop and

the dimension X of the cooker hob.

Below is supplied the table of comparison between

the dimension K to be created in the worktop and

the dimension Z of the cooker hob.

DIMENSION X DIMENSION Y DIMENSION Z DIMENSION K

300 270 600 560

600 565 900 879

700 565

900 878

In case of installation on an empty kitchen unit with doors, a separation panel must be placed under the hob.

Keep a minimum distance of 20 mm between the bottom of the hob and the surface of the panel, which must be

easily extractable to allow sufficient access for any technical assistance.

1 2 ... 8 9 10 11 12 13 14

No comments

Smeg SE2644ID1 Datasheet Page 13