Smeg SEI5632D User Manual download pdf (Page 7)

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

N Blue and blue Blue and blue N

L Black and brown Black L1

Brown L2

Attaching the seal - On-top

installation

1. Clean the worktop around the cut out

area.

2. Attach the supplied seal stripe to the

lower edge of the hob along the outer

edge of the glass ceramic. Do not

extend it. Make sure that the ends of

the seal stripe are located in the

middle of one side of the hob.

3. Add some mm when you cut the seal

stripe to the length.

4. Push the two ends of seal stripe

together.

Attaching the seal - Integrated

installation

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an angle

of 45°. They should fit in the corners of

the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

After you assemble the hob, seal the

remaining gap between glass ceramic and

the worktop with silicone. Make sure the

silicone does not get under the glass

ceramic.

Assembly

min.

50mm

min.

500mm

min. 60mm

If the appliance is installed

above a drawer, the hob

ventilation can warm up the

items stored in the drawer

during the cooking process.

You can instal a separation

panel but it is not mandatory.

7

1 2 3 4 5 6 7 8 9 10 11 12 ... 79 80

Comments to this Manuals

No comments