Smeg STA4645 User Manual download pdf (Page 79)

Rev 0.0 25

INSTALLATION INSTRUCTIONS EN

PLUG IS NOT SUITABLE FOR THE SOCKET, CALL IN A QUALIFIED

ELECTRICIAN TO FIT A SUITABLE PLUG.

The plug at the end of the power cord and the corresponding socket must be

of the same type and must conform to current regulations governing electrical

appliances. The plug must be accessible after installation. Never remove the

plug by pulling on the wire. If the power cord is damaged, have it replaced

by the manufacturer or an authorized service centre.

DO NOT USE EXTENSION CORDS, ADAPTORS OR SHUNT CON-

NECTIONS IN ORDER TO AVOID THE POSSIBILITY OF OVERHEAT-

ING OR BURNING, WITH CONSEQUENT FIRE HAZARD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT RE-

PLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNI-

CAL SERVICE CENTRE IN ORDER TO AVOID ANY RISK.

5.3 Commissioning

5.3.1 Installation procedure (all models)

Clean the underneath of the worktop lying over the dishwasher door (see ﬁ g.

5-15) and apply the steam guar

d, as shown in ﬁ g. 5-16 (see ﬁ g. 5-16 if the

adhesive guard is applied; see ﬁ g. 5-17 if the steel guard is applied). This guard

protects the worktop from steam and condensation when the door of the dish-

washer is opened at the end of the washing cycle.

Fig. 5-15

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 92 93

No comments

Smeg STA4645 User Manual Page 79